Synergy suspension warranty8/12/2023 Do not leave the seat uncovered in direct sun unless it is in use. In addition to these procedures, the seat should be hosed after exposure to salt water and left to dry. Maintenance procedures should be carried out every 100 boat hours. If the armrests, headrest extension, and rear grab handle are not installed when delivered, please contact Shark for instructions. Plinth showing the 8 bolts used for mounting to the desk (minimum).įollow the instructions for ULTRA and XTRA. Note that this may not be necessary for your application.įigure 2. The tear out force per bolt must exceed 500kg / 5000N to pass the stringent HSC2000 lateral loadings. Use a minimum of 8 bolts per seat as shown in Figure 2 and ensure the steel thick washers are used on the inside of the plinth. Drill the mounting surface in the correct positions. Ensure the template is oriented correctly and measure one of the dimensions once printed to confirm that it is the correct size. Use the A4 printable hole template and align this with the line you marked (print at actual size, with no scaling, on A4 paper). Once the seat is in the correct place, mark the mounting surface along the front edge of the plinth unit. Align the seat so that you can comfortably reach the controls, or handholds (if this is a passenger seat).Įnsure there is at least 4 inches of clear space all around you when seated, and consider the possibility that larger and smaller people may use the seat. If you are using the ULTRA seat, you may need a base (or Shark Plinth unit) to achieve the correct height. Move the seat into the correct position on board and have someone hold it by the rear. Seat to suspension mounting instructions. Mount the seat with the backrest of the seat nearest the Shark logo plate on the suspension.įigure 1. It is highly recommended that you consult your boat builder or a suitably qualified person to undertake the seat mounting process.Īlign the 6 bolts on the underside of the seat, with the 6 holes as shown in Figure 1, use the washers and nuts provided and tighten firmly. There are many factors such as the presence of fuel tanks, and the deck strength, thickness and composition etc, that we do not have any information for. This seat mounting information is a guide only, Shark takes no responsibility for any injury or damage occurring during or as a result of the seat mounting process. The fore-aft spacing of the holes is 30mm. The outer rows have centers 235 apart, the inner rows have centers 130mm apart. ![]() The top mounting surface has 4 rows of fore-aft bolt holes. Note that this may not be necessary for your application. ![]() Note: You may need to drill these holes to clear an M8 bolt.Īdditionally, a minimum of 4 bolts per side (8 bolts on the horizontal mounting surface) are recommended. If using your own base, the front diagonal face of the FLEX unit must be supported and have the two fastening bolts inserted to affix it. This can be purchased separately from Shark along with fasteners. You may require a base (or Shark Plinth unit) to achieve the correct height.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |